This is a public Discussion Forum  public


    Assigning frequencies within Group/Channel parameters?
    Topic posted November 30, 2013 by NollykinNovice, last edited November 30, 2013 
    84 Views, 1 Comment
    Assigning frequencies within Group/Channel parameters?

    Hi guys,

    Is it possible at all to set the Frequency Coordinator to only assign channels along the predetermined group/channel frequencies on a specific receiver type? I find when it calculates frequencies, it reports the direct frequencies (ie: 740.300 mhz) rather than group/channel numbers (ie Group: 1, Channel 1). I'd love to be able to set it to only assign frequencies that fall within a group/channel list?

    This isn't a problem, as I can assign manually by frequency, but I often find it quicker and easier to shout to a stagehand or setup-crew member "Tune it to group x, channel y!" rather than "tune it to 740.300 mhz!" :P

    Just wondered if this was possible?




    • Gino Sigismondi


      Thanks for the feedback. For UHF-R, Axient, and ULX-D, the answer is no. But for ULX and SLX, the option exists to use simple Group/Channel, or instead use what is called Master List mode that gives access to all the frequencies in 25 kHz steps. That is because access to Master List is more or less a "hidden" feature on those systems, simply because that level of user doesn't typically need access to that many frequencies.


    © 2009-2014 Shure Incorporated All rights reserved.
    • Privacy
    • Powered by RightNow